09-24-2022 07:42 AM
I know this printer is almost an antique, but, like many, I can't afford a replacement printer. The head clogged up on it recently and I soaked it in Windex for a couple days, flushed it out and it worked fine. However, a week later it stopped printing on group 1 again. I tried the Windex trick again but with no results. I soaked it again for a few more days, used a syringe to gently suck out and clogs but still no result. Print heads aren't cheap so I figure 'what the heck, I might take the print head apart and manually clean it' Has anyone on the the board ever taken apart a print head for cleaning, or to simply see how a print head is built? (yes, I would do that if the head was determined to be bad) What are some precautions I might want to take?
09-24-2022 08:33 AM
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.