01-04-2017 01:31 AM
My Pixma G3100 printer sporadically goes into continuous initialization and won't print. This happens without any change in computer connection (USB only) or computer system (Macbook Air currently running Sierra 10.12.2). Yesterday it was printing just fine and had been for weeks. Now it has gone into this continuous initialization which does not quit. Plenty of ink in all containers. Connections are all solid
This has been happening off and on for the last year. It is somewhat like an infinite loop. The printer suddenly goes into the loop and just as suddenly comes out of it and starts printing normally again.
Anyone else had this problem? What did you do?
01-04-2017 08:59 AM
Hi Maccraith,
It is recommended that you contact one of Canon's Technical Support Representatives. To contact a Technical Support Representative, please use the link below:
http://Canon.us/ContactLI
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.