Canon Community Canon Community
 


Reply
Highlighted
New Contributor
Posts: 2
Registered: ‎01-28-2019
Accepted Solution

TS8120 Display Window won't Close

Just fired up my new Pixma 8120 and don't understand the display window flap raising and lowering. At this juncture, I haven't figured out why it rises and what action would allow that window to return to verticle (closed).

 

Following my initial 'test' print, that flap opened to horizontal and there it remains.  Once it rises so that the window display is horizontal, is that where it stays?

Highlighted
Product Expert
Posts: 1,071
Registered: ‎11-19-2018

Re: TS8120 Display Window won't Close

Hi powepair,

 

Once the panel is in horizontal that is the position it will stay in while printing. When you are done printing, you will need to manually close the operation panel. When you go to close the panel, you may notice a little resistance about half way down and that is normal. The resistance is normal and you can keep pushing the operation panel close.

 

Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.

Highlighted
New Contributor
Posts: 2
Registered: ‎01-28-2019

Re: TS8120 Display Window won't Close

Arthur J - Thank you for the info.
powered by Lithium

LIKE US on Facebook FOLLOW US on Twitter WATCH US on YouTube CONNECT WITH US on Linkedin WATCH US on Vimeo FOLLOW US on Instagram SHOP CANON at the Canon Online Store
© Canon U.S.A., Inc.   |    Terms of Use   |    Privacy Statement