11-26-2017 09:09 PM
I have a Pixma 922 that is stuck in 2 sided mode. I am able to change this for a single copy using "Printer setting", but it immediately reverts back to 2 sided.
I have my original on the scanner surface, and hit the "copy" buttons on the right and it prints 2 copies of the original, one of each side of my paper.
Please note I am working from the printer itself and not from my PC.
How can I get the defaults changed to single sided for copies.
Solved! Go to Solution.
11-29-2017 06:35 AM
Hi lspalmer1965,
It is recommended that you contact one of Canon's Technical Support Representatives. To contact a Technical Support Representative, please use the link below:
http://Canon.us/ContactLI
11-29-2017 06:35 AM
Hi lspalmer1965,
It is recommended that you contact one of Canon's Technical Support Representatives. To contact a Technical Support Representative, please use the link below:
http://Canon.us/ContactLI
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.