09-05-2017 01:56 PM
Pixma MG3022 printer
Printer is feeding paper too quickly causing the margins to be disproportionate (when printing landscape the left margin is .75” and the right is 1.5”)
Troubleshooting attempts included:
restarting computer/printer
cleaning the feed following the instructions in the manual
placing one page at a time as well as a stack of paper
adjusting the paper guide so its tightly again the paper and not so snug
Nothing has made a difference.
Is there anyway to adjust the feeding speed?
Suggestions appreciated, thank you
09-06-2017 04:23 AM
Hi Jreynolds,
Based on the specfic issue, it is recommended that you contact one of Canon's Technical Support Representatives. To contact a Technical Support Representative, please use the link below:
http://Canon.us/ContactLI
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.