09-28-2020 02:45 PM
My printer colors were fine until I had to change empty cartridges. Now, my blue is a sickly, faded robins egg blue. I know there's a way to fix this using my iPad because it happened before quite a while ago but I, obviously, don't remember how to fix it and I, unfortunately, didn't write down the solution (but will this time!). I seem to remember something about cleaning the rollers manually, but mentally I can't connect dirty rollers with bad color.
I have looked on every menu and tried every adjustments but still keep printing this ugly blue. Any suggestions would be greatly appreciated!
Thank you in advance!
09-28-2020 08:05 PM
Is the printer also connected to a PC or laptop?
Did you run a nozzle check to be sure all is OK?
Check that all the tape is removed from the cartridges.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.