FAQ
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

MX920 with IMAC OS X el Capitan. Error 300. will not print. Will print after a few hours.

tayglen
Apprentice

‎11-06-2016 05:30 PM

Support Code : 300 The printer does not respond. Printer is properly connected to wifi network. After an hour or two printer activates and prints. For a short while it would print if re-started with print job waiting.

0 Likes
0 REPLIES 0
Announcements

04/16/2024: New firmware updates are available.

RF100-300mm F2.8 L IS USM - Version 1.0.6

RF400mm F2.8 L IS USM - Version 1.0.6

RF600mm F4 L IS USM - Version 1.0.6

RF800mm F5.6 L IS USM - Version 1.0.4

RF1200mm F8 L IS USM - Version 1.0.4


03/27/2024: RF LENS WORLD Launched!

03/26/2024: New firmware updates are available.

EOS R3 - Version 1.7.1

EOS R5 - Version 2.0.0

EOS R6 - Version 1.8.4

EOS 1DX Mark III - Version 1.9.0

WFT-R10 - Version 1.3.1


03/22/2024: Canon Learning Center | Photographing the Total Solar Eclipse
02/29/2024: New software version 2.1 available for EOS WEBCAM UTILITY PRO
02/01/2024: New firmware version 1.1.0.1 is available for EOS C500 Mark II

12/05/2023: New firmware updates are available.

EOS R6 Mark II - Version 1.3.0

EOS R7 - Version 1.4.0

EOS R8 - Version 1.2.0

EOS R10 - Version 1.4.0

Selphy QX10 - Version 1.1.0.0


11/13/2023: Community Enhancements Announced
09/26/2023: New firmware version 1.4.0 is available for CN-E45-135mm T 2.4 L F
08/18/2023: Canon EOS R5 C training series is released.

07/31/2023: New firmware updates are available.

CR-N700 - Version 1.2.0

CR-N500 - Version 1.3.0

CR-N300 - Version 1.3.0

CR-X300 - Version 1.1.0


06/30/2023: New firmware version 1.0.5.1 is available for EOS-R5 C
Copyright © 2024 Khoros, LLC