06-07-2016 12:58 PM
I dropped my Canon MG8120 and the lid and a few parts exploded all over the place. I manager to hook back up the ribbon cables and wires that communicate with the lid interface and it boots up with no errors but I cannot install the lid until I find where this spring goes and I think it has something to do with the counter balance for the weight of the lid. The spring does not have hooks and it's pretty heavy-duty, I think it has something to do with counter-balancing the lid, I just can't seem to find where it goes. Also, a plastic cover of some sort that I can't find a spot for, it's unbroken and seems to have hinge pins. A picture of both items can be seen here: http://i197.photobucket.com/albums/aa245/Christopher379/DSC_1976.jpg
I spent $20 on a service manual with illustrations but it did no good! Any help would be GREATLY APPRECIATED! Thanks!
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.