Canon Community Canon Community
 


Reply
Highlighted
Frequent Contributor
Posts: 92
Registered: ‎03-28-2015

Re: shutter release not working S100

I agree that just re-soldering will probably last a very long time. After all, most of the s100's out there never fail in this way. Too many do -- especially when one of them is mine. I think that on those that failed the original soldering was not quite hot enough,or the mating surfaces were not close enough or not enough flux flowed. I would be tempted when reheating to add a tiny tiny bit of additional solder -- if it looked like the original was skimpy. Also, now that we know the weak link we will take care not to press the shutter too hard.

powered by Lithium

LIKE US on Facebook FOLLOW US on Twitter WATCH US on YouTube CONNECT WITH US on Linkedin WATCH US on Vimeo FOLLOW US on Instagram SHOP CANON at the Canon Online Store
© Canon U.S.A., Inc.   |    Terms of Use   |    Privacy Statement