03-28-2022 05:26 PM - last edited on 03-29-2022 08:39 AM by Danny
I'm following what is explained in the manual but even if I set the bracketing, only one photo is shot. This in the modes P/Av/Tv/M. The flash is closed.
What am I missing?
[Third-party manual link removed and replaced with screenshots of the corresponding pages from the manual found on the Canon USA web site]
03-30-2022 07:56 AM
Hi there,
There are two things you will want to make sure are active. First, the image does not show it but when you are in the AEB setting and you adjust the wheel you should see three separate lines under the meter, each one indicating what each exposure will be relative to zero. Second, please make sure you are in the continuous drive mode, either low or high. The camera will only take one shot at a time if you are not in continuous shooting mode.
04-01-2022 02:46 AM - edited 04-03-2022 11:57 PM
@imessageapp wrote:I'm following what is explained in the manual but even if I set the bracketing, only one photo is shot. This in the modes P/Av/Tv/M. The flash is closed.
What am I missing?
Just to confirm you are holding the shutter down until it shoots all three images? It needed to capture them 1 at a time, usually through a rapid burst mode holding the shutter down. Single press (one after the other) for each of the 3 bracketed images may work too.
04-01-2022 01:21 PM
> Single press (one after the other) for each of the 3 bracketed images may work too.
No, it doesn't work
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.