My MF641 Laser Printer worked fine and then today it wont scan from the software, it says it can not communicate with computers....I can not use cord because it does not fit into my laptop. Meanwhile the printer then went "offline" and so I took it off the printers list on my mac and went to add it back but no air printer was found, nothing. Now my printer is not even on my lap top. I tried to redo everything as if new, but it says that is already set up. Can someone help me? Thank you so much, I must get important documents scanned in like now! I really appreciate your knowledge.
If the Mac can see the printer but can't addit, it could be caused by the drivers installed on the computer. You can try downloading and installing the recommended driver for the printer using the link HERE.
We would be happy to assist further with the issue. To provide some feedback or some troubleshooting steps, we would need some additional information. If you could reply to this message with the information below, we can provide some assistance.
12/05/2023: New firmware updates are available.
09/26/2023: New firmware updates are available.
08/18/2023: Canon EOS R5 C training series is released.
07/31/2023: New firmware updates are available.
05/18/2023: New firmware updates are available.
03/30/2023: New firmware updates are available.