02-14-2015 12:01 PM
I just bought it today. I was following the steps to install, and when i took of the plastik-slips from the toner, i could not push the tray back in again. It can't be pushed in without the toners either. It gets stuck ca half way in, and it feels like something on the right side is stopping the tray. Tried restarting a few times also without luck.
I cannot see what it could be (tried looking with a flash-light).
Any good ideas?
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.