03-01-2017 10:09 PM
(I'm a little late getting back to this, it's been a busy week.)
Wadizzle, it was a bit remiss of me to not mention it in the original post, but this is the 18-135 IS STM lens.
To answer your question about how close I was: I went back and looked at it again. 100 feet may have been too much -- I was still a good 50 feet away.
As far as as the focusing: I looked at the raw file on DPP; the nose of the engine is sharp, the center AF point was just to the left of the nose of the engine.
03-01-2017 11:25 PM
Tim, there's a lot of good information in your reply. I think I need to do a little more homework as far as DOF is concerned, but I'm starting to realize that I don't know as much as I thought I did.
Once again, thank you and everyone for your replies and information.
03-02-2017 01:00 AM
@GenXRailmedia wrote:Tim, there's a lot of good information in your reply. I think I need to do a little more homework as far as DOF is concerned, but I'm starting to realize that I don't know as much as I thought I did.
Once again, thank you and everyone for your replies and information.
Take a look at the link in my first reply. It is a link to a DOF chart.
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |