10-29-2017 08:40 PM
I had not used the scanner for a few weeks and tried to scan a few photos tonight and get an error saying that "Cannot start MP Navigator EX." and gives me 4 things to check. I checked all those things and uninstalled and reinstalled both the software and driver and am still getting this message. Any ideas what to try next?
10-30-2017 07:57 PM
Hi dougkanipe,
In order to better assist you, allow me to ask a couple questions:
I look forward to your reply.
10-31-2017 10:09 AM
It seems like I got an error one of the times but not I just get the pop up that says the MP software won't start and to try four things. The software and drivers were reinstalled from the Canon website. I am using Windows 10.
11-03-2017 11:37 AM
Hello.
Troubleshooting with our support group will be needed to narrow down the cause of your issue. Please contact our support group using the "Contact Us" link below for additional assistance.
This didn't answer your question or issue? Find more help at Contact Us.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.