12-08-2019 02:42 PM
You say you have removed the CF card.... Is there a remote possiblity that the tethered configuration is expecting the CF card to be there? Could you put in a CF card and try just to elimenate that option?
12-08-2019 02:46 PM
If I use WiFi to tether my Mark IV to my Windows 10 desktop computer I can successfully open Digital Photo Professional 4 and control the camer, EXCEPT for actually taking a picture. When the shot is composed and ready to take the message window to the left of the on-screen shutter release button has a warning message that states "No more shot [sic] is available." If I press the shutter release on the camera the topp display flashes "FULL" in the upper left corner where white balance is displayed. There is a freshly formatted (in camera) SD card and a freshly formatted (in camera) CF card. If I close out of the EOS utility I can shoot thousands of photos. Any advise on what I am doing wrong that causes the remote shooting window to show "FULL" ???
Now I am confused. Are you trying to use the EOSU or DPP to do Remote Shooting? Each app works independently of the other app.
12-08-2019 02:59 PM - edited 12-08-2019 03:10 PM
Yes, as shown below. However, you can shoot tethered directly from the EOS Utility and do not need to use DPP. I have DPP 18.104.22.168 (most recent) and if I wish to use DPP I have the following destination set (which also shows up in the EU shooting window):
12-08-2019 03:02 PM - edited 12-08-2019 03:02 PM
I have a 5DIV. I have just downloaded the software, installed it and connected to my PC via the cable. It all worked flawlessly.
12-08-2019 03:07 PM
@Tronhard - I'm glad that everything works for you, but what I am looking for is possible reasons why it does NOT work for me.
12-08-2019 03:08 PM
Yup, I am still confused. Which application are you using? EOSU or DPP4?
You are saying that it using DPP4 in the title. But now you say you are using EOSU.
12-08-2019 03:14 PM
That was not my point - think about it... If I am downloading the same software as you then the fact that it works for me should suggest we can elimenate the software from the suspects list.
12-08-2019 03:18 PM
12-08-2019 03:20 PM
I apologize - I have tried both, with the same result. DPP and EU both use the same shooting window which is where I see the problem. DPP actually launches EU to open the shooting control window, but opening DPP first is not required. Again, the lack of clarity was my fault, but the "FULL" message appears in the shooting control window whether launched from DPP (View>Remote Shooting Window) or from EU (Remote Shooting). It is the same shooting control window, regardless of the method used to launch "Remote Shooting"
12-08-2019 03:26 PM - edited 12-08-2019 03:27 PM
@Tronhard Thank you, that was a very helpful clarification, and a thought process I would not have managed without you spelling it out. I will re-install the firmware (if it will let me, given that the versions are the same) and if that doesn't work then I'll report back here and contact Canon. I agree with your logic and it seems the best way to isolate the issue, since everything else appears to work as expected.