12-13-2018 03:38 AM
Hi everyone,
Wondering if anyone else has come across this problem with the 5D II.
The LED will blink red when powering up but that's it. There is a noticeable grey tinge on the rear LCD monitor but nothing on the top LCD panel. Shutter also fires with no lens attached.
Have tried all the reset pathways. Thinking it might be the DC/DC PCB power board. Any insights or similar experience with this problem would be most appreciated.
Thanks.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.