02-12-2023 04:07 PM
I’ve got a non-working 70D and a working 80D with some corrosion on the hot shoe mount. Are the hot shoe mounts of the two models compatible, and is it a simple enough job to remove and swap them out?
02-13-2023 06:43 AM - edited 02-13-2023 03:17 PM
It might be possible. You’re getting awfully close to the pentaprism and carefully aligned components.
Typical [repair] of this kind would involve replacing the entire top assembly because of the time involved in disassembling and then reassembling the hot shoe.
02-13-2023 10:04 AM
Greetings,
Based on my research, they are the same. I don't believe Canon changed the way hotshoes were mounted (top vs. bottm) until the 90D. So you can change the shoe mount itself out fairly easily. You'll need two small (very small) screwdrivers. One flathead, one phillips. The flat head will be used to release the shoe insert. The is the piece that sits in the shoe and provides retention force. It slides out easily once the retention force is released. Be careful not to scratch up the contacts. The shoe mount itself is held on with 4 phillips screws. Normally you remove one at a time. apply loctite and tighten. This works if the shoe mount becomes loose and "floppy".
Replacing the shoe mount is a little harder because of alignment. Be sure you have the screws straight, do not cross-thread. Also do not use gorilla force to tighten. Snug is good, but they can strip if you use too much force.
The newer shoes all use a bottom mount retention and for this repair, I recommend sending the camera to Canon for proper disassembly, tightening and reassembly.
~Rick
Bay Area - CA
~R5 C (1.0.7.1) ~RF Trinity, ~RF 100 Macro, ~RF 100~400, ~RF 100~500, ~RF 200-800 +RF 1.4x TC, BG-R10, 430EX III-RT ~DxO PhotoLab Elite ~DaVinci Resolve Studio ~ImageClass MF644Cdw/MF656Cdw ~Pixel 8 ~CarePaks Are Worth It
12/05/2024: New firmware updates are available.
EOS R5 Mark II - Version 1.0.2
09/26/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.5.0
07/01/2024: New firmware updates are available.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.