11-05-2022 01:15 PM
So I took the screws out to try to fix then spring… didn’t work. But now I can’t get one of the screws back in… the bracket fell too low. Was wondering what size the screws were so I could try to get one just a little longer to pull the bracket up
11-06-2022 03:14 PM
I don't know the screw size, but was wondering if turning the camera upside down would cause the plate to fall towards the top of the camera and allow the screw to engage the plate.
11-06-2022 03:31 PM
Unfortunately not, it did for the other slots, however not for the last one. I tried magnet. I tried screwdriver with magnetic tip. Nothing.
11-06-2022 09:50 PM - edited 11-07-2022 05:25 PM
Canon did not design that part to be user serviceable. If you were to bring your 7D to Canon for service, they would sell you a new top cover and then install it for you. If you were to remove the top cover, you might be able to get it back together yourself.
This what the underside of the 7D hot shoe area looks like.
05/31/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.1.2
05/18/2023: New firmware updates are available.
EOS Rebel T100 - Version 1.1.0
EOS 5D Mark IV - Version 1.4.0
EOS 6D Mark II - Version 1.2.0
PowerShot Elph 360HS - Version 126.96.36.199
PowerShot SX420 IS - Version 188.8.131.52
PowerShot 620 HS - Version 184.108.40.206
PowerShot SX720 HS - Version 220.127.116.11
PowerShot G1X Mark III - Version 18.104.22.168
PowerShot G7X Mark II - Version 22.214.171.124
PowerShot G9X Mark II - Version 126.96.36.199
04/20/2023: New firmware version 1.4.1 is available for EOS R3
03/30/2023: New firmware updates are available.
EOS 1DX Mark III- Version 1.7.1
Speedlite EL-1 - Version 1.0.2
03/30/2023: Product Advisory for EF50 F1.2 L USM
03/30/2023: Product Advisory for EOS R10
2/07/2023: New product announcements!EOS R8 EOS R50RF-S55-210mm F5-7.1 IS STMRF24-50mm F4.5-6.3 IS STMRF15-30mm F4.5-6.3 IS STM
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.