02-03-2018 09:06 PM
Hi,
If I hold down the back-button focus and take a picture, the AF point is displayed upon review. However, if I release the back button to recompose, it is not displayed. I do have focus disabled from the shutter button. Any ideas?
As I write this, maybe that is normal behavior. In the picture from recomposing, the initial focus point may not even align with the 11 focus points so the camera couldn't put a point out in 'space'.
I think I answered my own question, but will post for confirming my conjecture.
Dave
02-03-2018 11:09 PM
That is the normal display for Canon's DPP software.
If you are not pressing the BBF button, then no AF points are active. However, some software can show you which AF locked focus, even though it could be idle when the shutter fired. An old plug-in for Adobe Lightroom could do this.
02-04-2018 10:00 PM
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.