04-17-2023 03:02 PM
Hello,
I've been having this issue for a while. About 85% of the time my IP8720 wont print to the edge of my matte 5x7 paper.
The printer settings are set to full bleed (borderless), photo printing, high quality, with the borders extended. I've tried printing from photoshop, and CSP, with the trays all the way extended, or retracted. I've tried feeding paper in one at a time, or in small groups, nothing is working. It seems as though the printer pulls the paper forward too far, then backs it up, but not enough because it still prints too high on the page and leaves a white bottom edge. I've also tried printing with the 'paper weight' disabled and enabled, it does nothing.
I've tested out glossy paper it has a similar issue, though not as bad.
I've also tested out printing on standard printing with high quality printing and the matte paper settings. I get slightly better results with only 40% chance of a misprint, but it's still too high when I need to print these for a small business.
Larger sizes print fine, it's only the 5x7s.
Any help or advice would be great, thank you!
Printing on a Dell, windows 10, from either Photoshop or Clip Studio Paint.
07/01/2024: New firmware updates are available.
06/06/2024: New firmware updates are available.
EOS R6 Mark II - Version 1.4.0
Speedlite EL-5 - Version 1.1.0
Speedlite Transmitter ST-E10 - Version 1.1.0
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.