MX 922 "printer could not be detected on the network"

thinders1951 — Tue, 19 May 2020 23:38:52 GMT

Win10 , printer has worked fine for a long time.

I had to use the priter to recieve a FAX

After that the printer would no longer print or scan

Removed the printer via Win10 Control -- > Printer / Scanner

Re ran the SW from the Canon Site mp68-win-mx920-1_01-ea32_2

Select Wireless connection

When I do I get this:

The SSID shows in the list.

The instructions are ......useless

I seaarched the forum.

I disabled IPV6 and DRX

I ensured the printer is on the network. Re-did, several times. Router (Netgear R6200) shows it connected, it worked belfore on this Router

Printed out Network Config Page Which shows "Active" and on the same IP address as the router.

Ran the IJ Netowrk tool .......says "nnot found.

Multiple re-boots etc no help.

Suggestions???

Re: MX 922 "printer could not be detected on the network"

thinders1951 — Wed, 20 May 2020 18:56:41 GMT

FIXED:

The issue was with my ROUTER which was not recording the connected devices correctly.

I used WPS to put on network, and the IP address had already been assigned to another device.

I rebooted router.

I used MANUAL IP assignmennt at printer after WPS

Re installed the SW and everything worked.