topic Can't enter wifi password on Canon Pixma TS9020 in Printer Software & Networking

Can't enter wifi password on Canon Pixma TS9020

SteveC68 — Fri, 10 Apr 2020 03:11:31 GMT

I have a Canon Pixma TS 9020 and we recently changed our router password. When I try to connect the printer to the wifi it doesn't ask for a new password. Instead it immediately tries to connect to the wifi and then fails the login. It says I should check the password, but NEVER lets me actually enter a password. How do I enter the wifi new password into the printer?

Thanks,

Steve

Re: Can't enter wifi password on Canon Pixma TS9020

shadowsports — Fri, 10 Apr 2020 05:47:04 GMT

Greetings,

Best to perform set up again following these instructions.

https://support.usa.canon.com/kb/index?page=content&id=ART167444

Re: Can't enter wifi password on Canon Pixma TS9020

Hector — Thu, 16 Apr 2020 18:51:05 GMT

Hi SteveC68,

If you are having problems with getting a chance to enter your password, it will usually mean the printer is not getting the proper password request from the router. In this situation, you can try unplugging your router from the power for 5 seconds and then plugging it back in. If you still have problems, I would suggest trying to connect using a different setup option.

The setup option I would suggest in this situation would be a WPS pin code setup. You can follow the steps HERE to find the instructions on how to run the printer's WPS pin code setup.

If you still have an issue with setup, please reply to this message with the information below so we can better assist.

What model router are you trying to connect to?
If you select any other routers in range, do you get a prompt to enter the password?

Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.

Re: Can't enter wifi password on Canon Pixma TS9020

Seross531 — Thu, 11 Apr 2024 05:02:55 GMT

Hi hector,

I am also having this problem, can’t seem to figure out how to enter a pin on my router but when I select another router that’s within range, I’m prompted to enter a passcode but not when I’m trying to connect to my router. Can you assist?