https://community.usa.canon.com/t5/EOS-DSLR-Mirrorless-Cameras/EOS-1DX-III-firmware-version-1-2/m-p/317766#M75093 <P>I updated my 1DX III body to firmware version 1.2 this morning and it went smoothly although it took a little longer than the first firmware update I did back in April. I had to go into my own memory banks to remember where I put the CF Express card reader before I could do the update because I always transfer files via its ethernet connector.</P><P>&nbsp;</P><P>Like Windows, the percentage complete status bar has little bearing on the actual time with it moving swiftly through some areas and very slowly through others.&nbsp; At the start it sits at 0 percent for a couple of minutes before starting to count up 1 percent at a time so don't be concerned if it appears to be doing nothing at first.&nbsp; Midway through it starts flying and then the last 10 percent slows way down again.&nbsp; Total time was under 10 minutes, I didn't time it because I was busy processing files in DPP.</P><P>&nbsp;</P><P>I shot a few images just to make sure there were no obvious glitches and it worked fine.&nbsp; The listed updates are mostly in areas I could care less about but some were potentially useful for what I do.</P><P>&nbsp;</P><P>Rodger</P> Sat, 29 Aug 2020 15:10:46 GMT wq9nsc 2020-08-29T15:10:46Z https://community.usa.canon.com/t5/EOS-DSLR-Mirrorless-Cameras/EOS-1DX-III-firmware-version-1-2/m-p/317766#M75093 <P>I updated my 1DX III body to firmware version 1.2 this morning and it went smoothly although it took a little longer than the first firmware update I did back in April. I had to go into my own memory banks to remember where I put the CF Express card reader before I could do the update because I always transfer files via its ethernet connector.</P><P>&nbsp;</P><P>Like Windows, the percentage complete status bar has little bearing on the actual time with it moving swiftly through some areas and very slowly through others.&nbsp; At the start it sits at 0 percent for a couple of minutes before starting to count up 1 percent at a time so don't be concerned if it appears to be doing nothing at first.&nbsp; Midway through it starts flying and then the last 10 percent slows way down again.&nbsp; Total time was under 10 minutes, I didn't time it because I was busy processing files in DPP.</P><P>&nbsp;</P><P>I shot a few images just to make sure there were no obvious glitches and it worked fine.&nbsp; The listed updates are mostly in areas I could care less about but some were potentially useful for what I do.</P><P>&nbsp;</P><P>Rodger</P> Sat, 29 Aug 2020 15:10:46 GMT https://community.usa.canon.com/t5/EOS-DSLR-Mirrorless-Cameras/EOS-1DX-III-firmware-version-1-2/m-p/317766#M75093 wq9nsc 2020-08-29T15:10:46Z