https://community.usa.canon.com/t5/Desktop-Inkjet-Printers/MX-920-Cover-bumped-out-of-place/m-p/224188#M50396 Problem solved! With a little more patience and a little more jiggling back and forth the cover slipped into place. I did a scan operation afterward and found everything was back to normal.Thanks to all for your attention anyway. Fri, 10 Nov 2017 16:11:28 GMT coverprob 2017-11-10T16:11:28Z https://community.usa.canon.com/t5/Desktop-Inkjet-Printers/MX-920-Cover-bumped-out-of-place/m-p/224148#M50395 <P>I inadvertently caused my mx920 printer to fall off the 9 inch high platform it was on. The cover popped out of the socket on the right hand side and I can't get it to pop back in again so there is a 3/4 inch or so air gap on the right hand side. Left hand side looks OK. . Nothing looks damaged. There must be a certain way of doing this but I haven't found it yet. Please help. Thank you.</P> Thu, 09 Nov 2017 21:01:30 GMT https://community.usa.canon.com/t5/Desktop-Inkjet-Printers/MX-920-Cover-bumped-out-of-place/m-p/224148#M50395 coverprob 2017-11-09T21:01:30Z https://community.usa.canon.com/t5/Desktop-Inkjet-Printers/MX-920-Cover-bumped-out-of-place/m-p/224188#M50396 Problem solved! With a little more patience and a little more jiggling back and forth the cover slipped into place. I did a scan operation afterward and found everything was back to normal.Thanks to all for your attention anyway. Fri, 10 Nov 2017 16:11:28 GMT https://community.usa.canon.com/t5/Desktop-Inkjet-Printers/MX-920-Cover-bumped-out-of-place/m-p/224188#M50396 coverprob 2017-11-10T16:11:28Z