topic Re: should my hf r500 rattle when shaken? in Camcorders

should my hf r500 rattle when shaken?

mcfallison — Sun, 03 May 2015 00:43:08 GMT

My HF R500 rattles when shaken and there is a lot of color fringing at high contrast edges in the image. And soft picture. Does anyone else have these characteristics?

Re: should my hf r500 rattle when shaken?

mcfallison — Wed, 06 May 2015 02:29:11 GMT

Okay. The color fringing is very noticeable. Just trying to figure out if I have a bad camcorder. See the white t-shirt? And the green shirt at the shoulder?

Re: should my hf r500 rattle when shaken?

mcfallison — Wed, 06 May 2015 02:30:22 GMT

And then there's this...

Re: should my hf r500 rattle when shaken?

Tim — Thu, 07 May 2015 04:31:42 GMT

Hello Mcfallison,

The rattling that you are hearing is no doubt a vertical orientation sensor in the camera. Unless there are apparent issues with operation or misuse, I believe there is little cause for concern here.

With regards to the color fringing, it does seem to occur around the highlights and coupled with the soft appearance my thoughts are that the image is overexposed (and should be compensated for) but also that we may wish to check your lens to ensure no smudges or areas which require cleaning are present. Any filters you may use should be removed for our testing purposes.

In your reply you may also want to include shooting modes, applicable shooting/ exposure characteristics and whether or not the majority of your shooting, including the image of our moon, is done hand held or by support of some kind.

Re: should my hf r500 rattle when shaken?

mcfallison — Thu, 07 May 2015 15:05:42 GMT

Thanks for your reply. Both were shot on tripod. The moon shot was manually underesposed. I don't remember if the fishing shot was.

I don't see anything on the lens. It looks clean.

I usually shoot in P mode without any scene mode.

Re: should my hf r500 rattle when shaken?

Tim — Fri, 08 May 2015 21:06:06 GMT

Hi Mcfallison,

The fishing image seems to be overexposed, not under. I would close down the iris in order to darken the image and thus lessen the intensity of the highlights.

If the issues persist and you wish to have your camera evalauted, you can set up service through our web site.

http://www.usa.canon.com/cusa/support/consumer