05-02-2024 07:16 PM - last edited on 05-02-2024 07:22 PM by Tiffany
I recently bought an ImageFormula R10 and have been trying to make sure I have the latest software, presuming there are any updates available.
I know it comes with the built-in OnTouchLite sofware, but in browsing the Canon site for information, I've found indications of CaptureOnTouch Pro V4.5 as well as V5. But are either of those meant to be used with/by this R10 scanner?
I don't want screw up anything on the scanner, though I always prefer to have the latest software if possible. But since this scanner comes with the software built-in, would whatever gets installed on my PC by the 'Pro' versions even be used?
Any advice or suggestions will be appreciated. Thanks.
05-09-2024 11:55 PM
Good evening / morning,
It couldn't hurt to try! The worst thing it will do is notify you that it's not compatible.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.