10-28-2017 09:48 PM
Hello all,
I have a brand new Pro 10 that I just took out of the box tonight. After aligning the head and running a test page without incidence, I excitedly printed three of my own shots, each of which resulted in flawed results.
At the very end of the process (in the last inch of the page), the printer head seems to get stuck on something inside, causing the paper to skew approximatley 30-dereeas to the side, thereby ruining the print. I've attached a sample of the results below.
Perhaps I missed a piece of factory tape internally? Has anyone encountered this before?
Thanks for your assistance.
10-29-2017 07:13 AM
Double check that your media setting is correct for the paper being used.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.