06-17-2017 10:45 PM
Trying to set up my new MX922. When I turn it on I get a message “Support code 5101. Remove the protective material if it is attached to the holder and turn off power and back on.” There is a diagram showing the top open and a bit at the side. I have removed all the protective plastic and tape I can find. I have turned the printer off and on several times but get the same message. Pressing the Menu button does not change it. What should I do now? Is there a place where I could have missed protective material, or a way to get past this message? adTHANKSvance!
07-19-2018 05:47 PM
Not sure if you figured it out yet . But that orange tab comes out of that spot. I ended up chatting with support;
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.