Canon Community Canon Community
 


Reply
Occasional Contributor
Posts: 9
Registered: ‎01-06-2014

Re: MX922 scanner problem message: set the pc to start scanning

Unless you are scanning to a local disk, such as a USB drive, you have to tell the MX922 where to send the scan results, and that must be a computer that can be found on the network.  I believe that usually any machines that have the MX922 defined as an available scanner should be visable as choices to have the scan file sent to them.  I also think that the MX922 should remember the last computer delivered to unless the MX922 has been powered off, in which case you probably need to select a computer again. 

New Contributor
Posts: 1
Registered: ‎06-13-2018

Re: MX922 scanner problem message: set the pc to start scanning

 Thank you so much for sharing the simple solution that Canon could / would not!  Your solution was a real time saver for me!!

powered by Lithium

LIKE US on Facebook FOLLOW US on Twitter WATCH US on YouTube CONNECT WITH US on Linkedin WATCH US on Vimeo FOLLOW US on Instagram SHOP CANON at the Canon Online Store
© Canon U.S.A., Inc.   |    Terms of Use   |    Privacy Statement