Canon Community Canon Community
 


Reply
New Contributor
Posts: 2
Registered: ‎11-09-2017

MX 920 Cover bumped out of place

I inadvertently caused my mx920 printer to fall off the 9 inch high platform it was on. The cover popped out of the socket on the right hand side and I can't get it to pop back in again so there is a 3/4 inch or so air gap on the right hand side. Left hand side looks OK. . Nothing looks damaged. There must be a certain way of doing this but I haven't found it yet. Please help. Thank you.

New Contributor
Posts: 2
Registered: ‎11-09-2017

Re: MX 920 Cover bumped out of place

Problem solved! With a little more patience and a little more jiggling back and forth the cover slipped into place. I did a scan operation afterward and found everything was back to normal.Thanks to all for your attention anyway.
powered by Lithium

LIKE US on Facebook FOLLOW US on Twitter WATCH US on YouTube CONNECT WITH US on Linkedin WATCH US on Vimeo FOLLOW US on Instagram SHOP CANON at the Canon Online Store
© Canon U.S.A., Inc.   |    Terms of Use   |    Privacy Statement