03-03-2013 09:13 AM
03-06-2013 05:51 PM
Hi Waterman,
I'm sorry to hear about the E2 error code. Note, if E2 or E002 has been displayed, it indicates an internal processing component requires attention. However, you can try resetting your copier as described below if you haven't done so already. This can sometimes offer a simply solution:
Note: Disconnect your unit from the current power source for 10-30 minutes.
1. Plug your copier into a different known working power outlet direct to the wall.
Note: Do not connect power cord to a surge, power or extension strip/cord.
2. Determine if the copier reaches the stand-by mode to make a test copy.
If the error remains, or you are experiencing a different error code, please contact us for further assistance. There are also options available for your consideration.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.