02-06-2018 08:07 AM
I have had an MB2350 for several years with no previous problems - but now having two issues with copying from the ADF.
First problem is a vertical line on prints for which I have found another forum thread with various suggestions. I have tried some but not all yet so hope to clear this problem soon.
The second problem arose at the same time so just wondering if there is a common fault. I have set the copying to do double-sided printing and if I do this from the platen it works fine. But if I try to use the ADF then it produces single sided prints for each side.
Grateful for any suggestions.
05-07-2018 11:32 AM
Troubleshooting with our support group will be needed to narrow down the causes of your issues. Please contact our support group using the "Contact Us" link below for additional assistance.
This didn't answer your question or issue? Find more help at Contact Us.