06-17-2017 12:17 AM
Hi,
I have a 3200F CanoScan. It was working well untill today that it starts to show multiple vertical lines all over the scanning area in preview and final image. Is it a serious hardware damage?
06-28-2017 06:38 AM
Hi ehsan,
What version of Windows (or Mac OS X) is installed on your computer?
07-01-2017 01:00 AM
Hi,
I use Windows XP (SP3) on my computer.
In the meanwhile I could fix the problem by click on "Calibration" in ScanGear CS. I had to calibrate it for about 15 times and then the lines disappeared. But the next time I wanted to use the scanner, they were back. This time they disappeared after 15-20 times of calibration.
That seems that I have found the source of the problem. But I'm afraid that I need to do this time-consuming process every time I want to scan.
07-01-2017 03:16 PM
Hello.
If the issue persists after calibrations have been performed, troubleshooting with our support group will be needed to narrow down the cause of your issue. Please contact our support group using the "Contact Us" link below for additional assistance.
This didn't answer your question or issue? Find more help at Contact Us.
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.