Canon Community Canon Community
 


Reply
New Contributor
Posts: 1
Registered: ‎04-14-2018
Accepted Solution

CanoScan 9000F Mark II Adjustments

When aligning photos against the left border of my scanner, 1/8 inch (slightly more) of the right side of resultant image is truncated. When aligning the photo on the right side of the scanner the truncation is less than 1/32 inches and acceptable. Is there an adjustment to be made to correct this? This is my first post to the "canoncommunity" and I was very surprised there is no category devoted to scanners. Who can be contacted to resolved this. I posted to this section after searching and finding that most scanner issues are posted in "General Printer Discussion" subset of "Printers". Establishing a "Scanner" subset of "Printers" would be more helpful.
Highlighted
Product Expert
Posts: 2,686
Registered: ‎10-16-2012

Re: CanoScan 9000F Mark II Adjustments

Hello.

 

Troubleshooting with our support group will be needed to narrow down the cause of your issue. Please contact our support group using the "Contact Us" link below for additional assistance.

This didn't answer your question or issue? Find more help at Contact Us.

Did this answer your question? Please click the Accept as Solution button so that others may find the answer as well.
powered by Lithium

LIKE US on Facebook FOLLOW US on Twitter WATCH US on YouTube CONNECT WITH US on Linkedin WATCH US on Vimeo FOLLOW US on Instagram SHOP CANON at the Canon Online Store
© Canon U.S.A., Inc.   |    Terms of Use   |    Privacy Statement