01-28-2013 04:34 PM
I have a new rebel t3i when i set the flash to manual the flash output level for the built in flash will not go higher than 1/4 power. it will go lower down to 1/128 power but not higher than 1/4. I contacted canon and they replied back that they do not know. I sent a second e-mail and that person said that is the way it works. I don't beleive these two people really know, and all they do is answer e-mails. Somebody must know why this happens. Any help would be appreciated.
01-28-2013 08:37 PM
I think you're mis interpreting the manual. From reading the t21 & t41 as well as the 7D manual you don't have the ability to set the power output of the built in flash. You do have that available on the Canon Speedlights (ad on flash units) which are specified as fully compatible with your camera. .
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.