03-21-2018 11:52 AM
I am having problems printing out a "Pattern check" to see if the nozzles need cleaning.
I clicked on "Troubleshooting".
"Print Head Cleaning" pop up appeared. I clicked on "execute". Another pop up appeared that said "do not start another operation until the cleaning has finished". I clicked "ok".
Another pop up appeared "Nozzle check". I clicked "print pattern". I waited.
Another pop up appeared "do not start another operation until the current one has finished"
I clicked "ok". I waited.
Then the "Pattern check" pop up appeared.
I clicked "exit".
Yet again, nothing happened.
Any ideas where I am going wrong please?
04/16/2024: New firmware updates are available.
RF100-300mm F2.8 L IS USM - Version 1.0.6
RF400mm F2.8 L IS USM - Version 1.0.6
RF600mm F4 L IS USM - Version 1.0.6
RF800mm F5.6 L IS USM - Version 1.0.4
RF1200mm F8 L IS USM - Version 1.0.4
03/26/2024: New firmware updates are available.
EOS 1DX Mark III - Version 1.9.0
12/05/2023: New firmware updates are available.
EOS R6 Mark II - Version 1.3.0
07/31/2023: New firmware updates are available.
Canon U.S.A Inc. All Rights Reserved. Reproduction in whole or part without permission is prohibited.